Dual Channel 1.5A DC Motor Driver PWM Speed H-Bridge Stepper L298N
Detail Produk Dual Channel 1.5A DC Motor Driver PWM Speed H-Bridge Stepper L298N
DeskripsiĀ Dual Channel 1.5A DC Motor Driver PWM Speed H-Bridge Stepper L298N
MakassarRobotika merupakan Pusat Penjualan / Supplier Komponen Robotika Indonesia Timur yang berbasis di Makassar. Kami menyediakan komponen robotika atau mikrokontroller seperti arduino, sensor, modul, display, roda, motor gearbox, servo dll. Harga murah terjangkau dengan kualitas bersaing.
Suitable for battery-powered smart cars, toy cars, robots.
Power supply voltage is 2V ~ 10V, can drive two DC motors or a 4-wire 2-phase stepping motor simultaneously.
Can achieve positive and negative and speed control function
Single circuit operating current 1.5A continuous current, peak current up to 2.5A, over-heat protection and can be automatically restart.
Features:
1. Using imported original professional motor driver chip, built-in MOS switch, minimal heat, low heat,no leat sink needed, small size, low power consumption, ideal for battery powered. Perfect replace L298N.
2. 2-way 1.5A x 2, the peak current up to 2.5A, built-in over heat protection circuit automatic recovery after the temperature dropped.
3. INx connect with microcontroller and other signal sources, MOTOR-A and MOTOR-B connect with motor.
Cautions:
1. Power positive and negative reversed will cause damage to the circuit.
2. Short circiut to ground or output port, and in case of motor locked rotor, the chip will over-heat protection. But please note that the chip will burn if the voltage over 10v and the peak current over 2.5A.
Dimensions
0.98 in x 0.83 in x 0.28 in (2.5 cm x 2.1 cm x 0.7 cm)